Set up TEK-link VPN router (purchased with account)

Koben Chou -

Thank you for purchasing the TEK-Link VPN router, please follow the steps below set it up.

If you have any questions of any steps, please contact us at 021-50807398 or email us at support@tekshanghai.com.

Step 1  Connect the router

To begin, install the antennas first, then take the Ethernet cable supplied with the TEK-Link router and attach one end to the Internet port (blue port) on your VPN router.

Attach the opposite end of the ethernet cable to an open LAN port on your existing Wifi router or the wall internet port.

Plug in the power supply.

 

Step 2,  Connect the wifi and choose the server

Use your computer or mobile device to search available Wifi connections named TEK-Link, (or TEK-Link-5G if you bought the N66 or AC68)

When connecting to the TEK-Link Wifi connection you will be prompted for a password. Use default password breakonthrough to connect.

Wait around 3 minutes, then type 192.168.10.1 in the browser address bar, or click here, then you need type in the user name: admin, password: admin

You can then see the Astrill VPN on the left sidebar.

Click Astrill VPN, then Site Filter, and change the setting to Tunnel only International sites (means the local sites will have full speed).

Go back to the VPN tab, you should see the Astrill control panel and you can choose the server you would like to use. Click here to view the fastest Astrill servers of the day.

MAKE SURE you change the Protocol to Router VPN UDP, and check the Enable Accelerator and Start Automatically before you click Connect.

It will take up to 15-20 seconds for the router and Astrill to establish the connection. When you see Connected in green color on the top right, then you are ready to go. Enjoy the wide-open Internet.

**If you get stuck in the page while connecting, thats means the connection is not good, please close the current page, go to step 5 (below), and change the server.

Step 3 – Checking the speed and change the server

After successfully connecting to the server: As Astrill VPN has many users all over the world, some servers may be very slow. To test the speed of the server, you can download the app called Speed Test from the Apple App Store.

Open the App, tap Begin Test, if the speed is above 2Mb/s or 200 KB/s, you should have a good connection to stream videos or websites, if its too slow, you need to change the server of the VPN service, please follow step 5.

Step 4 – How to change the server in the future

If you notice that the speed is getting slower from the TEK-Link wifi, click 192.168.10.1, and put the username: admin, password: admin.
Navigate to the Astrill VPN tab on the left side bar, and click Disconnect , and change to a new server and click Connect again. Use Step 4 to check the speed.

**If you are unable to connect and require assistance – please feel free to contact us.

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.
Powered by Zendesk